Vulcan-materials GTS12-2 Instrukcja Użytkownika

©ITW Food Equipment Group, LLC 3600 North Point Blvd. Baltimore, MD 21222 RETAIN THIS MANUAL FOR FUTURE USE FORM F-38300 (05-13) OPERATION AND FIEL

- 10 - 4. Securely tighten the mounting bracket system assembly bolts at the left and right side mounti

- 11 - 8. Drill the remaining holes through the side mounting brackets into the griddle chassis. Insert and tighten screws as shown in Fig. 7.

- 12 - It may be necessary to angle the griddle and hang one of the four legs off the edge of the table at a time to complete

- 13 - 14. Place cardboard or other protective covering on the gas griddle surface to prevent scratching. 15. Se

- 14 - 17. Set lower mounting spacer in place. Apply a thread locking compound to (

- 15 - GTS12‐1&GTS12‐2Threadsshowing(X) HeadWeight(lb)Flush/0 +11

- 16 - 20. Reinstall the tension rod cover and tighten screws. Fig. 18 21. Check range of motion as shown in Fig. 19. The assembly

- 17 - ELECTRICAL CONNECTIONS Electrical and grounding connections must comply with the applicable portions of the National Electrical Code and/or

- 18 -

- 19 - TROUBLESHOOTING PROBLEM POSSIBLE CAUSES Heat does not come on when power switch is turned ON 1. Thermostat set too low. Turn to higher settin

- 2 - TABLE OF CONTENTS OPERATIONS Installation…………………………………………………………………………………………..Electrical Specifications……………………………………………………………………………Controls……

- 20 - ACCESSORIES GTS12 ELECTRIC GRIDDLE TEFLON WRAP KIT INSTALLATION The griddle and its parts are hot. Use

- 21 - 3. Using water, rinse the Teflon sheet and hardware thoroughly on both sides. 4. Dry the Teflon sheet and hardware using a clean soft cloth.

- 22 - NOTES

- 3 - HEAVY DUTY ELECTRIC GRIDDLE TOP GENERAL Heavy Duty Electric Griddle Tops are produced with quality workmanship and materials. Proper install

- 4 - UNPACKING This griddle top was inspected before leaving the factory. The transportation company assumes full responsibility for safe delivery u

- 5 - To raise the assembly to the 47˚ position 1. Lift by the handle only 2. Raise until assembly locks it

- 6 - USING THE ELECTRIC GRIDDLE To preheat, wipe the griddle top plate with cooking oil and set the thermostats for the desired temperatures 10-12

- 7 - ONCE PER DAY Thoroughly clean all stainless steel exterior panels and surfaces. Clean the cooking surface with a non-metallic scouring pad (Sc

- 8 - MAINTENANCE The griddle and its parts are hot. Use care when operating, cleaning or servicing the griddle. Disconnect power supply and fol

- 9 - ASSEMBLY The griddle and its parts are hot. Use care when operating, cleaning or servicing the griddle. Disconnect power supply and follow